Material: Red Copper fin + Brass water chamber. Motor: three-phase permanent magnet motor. Minimum starting voltage: 3.8V. Power interface: large 4P D port. PWM automatic temperature control: support.
Extended function: temperature display + detachable water tank. 120 120 25 mm/ 4.7 4.7 1.0 in. Fan speed: 1200 ± 10% RPM. Maximum static pressure: 1.703mm-H20. Working voltage: 10.8-13.2VDC.
Lock the fan and water row bracket with M332 and M335 screws on the water line. The opposite side of the water exhaust fan is fixed with the M312 screw. Lock the two 90° brackets on the pump bracket with M416 screws + M4 nuts. Lock the 90° bracket to the bottom of the pump with M38 screws. Lock the pump with the M312 screw on the water line. Quickly screw the hard tube, 90° elbow, and pagoda on the water pump and water line. Install the quick-twist on the two ends of the hard pipe, then connect the two ends to the water drain. And the water pump respectively, that is, the installation is completed.Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering. Instead of leaving negative/neutral feedback or opening a dispute. Our listing price includes the value of goods, packaging cost, and export. Please check with your country's.
We will reply your message within 48 hours. If you do not receive our reply within 48 hours, pls. Post a message again because sometimes our message system may block some emails. If you are satisfied with our service, pls.Our aim is to provide Level Customer Service, your recognition will encourage us greatly and serve you better. We strive to keep all our customers satisfy. We will do our up most to exceed your expectations in customer service, communication and dispatching of your orders. This item is in the category "Computers/Tablets & Networking\Computer Components & Parts\Fans, Heatsinks & Cooling\Water Cooling".
The seller is "globeselling100" and is located in this country: CN. This item can be shipped worldwide.