PLEASE NOTE: This kit is a set of RS36 Carburetors only with no sleeves fitted for 55mm Inlet / 42mm Outlet. There is 3 other variations of this kit which are available in separate listings. These Mikuni RS36-D3-K RS carbs will breath a whole new lease of life into your machine with around a 25% increase in power, whilst making it perform and operate as it should. You will very quickly realize that the expense of a rebuild of your old worn OEM carbs can far exceed the cost of these new units and also unfortunately as with many rebuilds now days you only have the option in many cases of gambling with very poor quality aftermarket parts. Considering this and if intending to ride and enjoy your motorcycle it makes good sense to retire your OEM carbs into the cupboard and step up to a set of RS's.
Before rushing in and ordering please firstly check your carb spacing and carbie sizes for compatibility. These are not suited for downdraft engines.
A= 77mm (spacing centre to centre between carb 1 & 2). B= 93 (carb 2 & 3) see note below if different.C=77mm (carb 3 & 4). If the centre spacing between the centres of your carbs #2 and 3 is 85mm, rather than the as supplied 93mm, two of the outside carbs will need to be unbolted and then slid in so as to align with the second set of provided securing points and then re-fixed. Due to limited demand for these carbs to suit 86-87 Yamaha FJ 1100 and 1200 engines along with some other applications such as Kawasaki ZL1000 with the 85mm centre measurement the factory no longer markets them assembled in this configuration thus requiring you the end user to make the adjustment and then re-synchronize the slides. The carb dimensions for motor and air-box fitment comparison are listed below and reference to the dimensions picture. If these dimensions are not matching your cabs we have new engine mounting flanges and or sleeves for up sizing, down sizing and increasing the carbs front to back length to match most OEM items. All sleeves along with any other accessories are found in the "RS carb Accessories" pages located in the main menu "RS Smoothbore Kits" option's drop list. A= The OD at the motor end on 36's is 42mm.
D= OD at the air-cleaner end is 55mm. B= Front to back length is 100mm.Pilot Jet: VM28/486-17.5, Needle: 9DZH5-50, Needle Jet: P-4 (568 Series), Main Jet: N100.604-120/130. We have twin throttle and cable assemblies available. Velocity stacks which have no form of filter in them (15, 30,50 and 75mm long) for racing. We have express options available for all our products also. Townsville to Brisbane 3 days, Townsville to North/Just South and West is usually 1-2 days. NSW ACT & VIC 4-6 days, TAS & SA 4-8 days, WA & NT 8-12 days. NSW ACT & VIC 2 days, TAS & SA 2-3 days, WA & NT 3-4 days. This is entirely out of our control if this occurs. THIS IS JUST PLAIN OLD COMMON SENSE. Please also note that international parcels HAVE to be signed for and all parcels whether domestic or international are fully insured. THE FOLLOWING INFORMATION IS FINAL. THIS IS FINAL AND NO OTHER EXCEPTIONS!
This item is in the category "Vehicle Parts & Accessories\Motorcycle & Scooter Parts & Accessories\Air Intake & Fuel Delivery\Carburettors". The seller is "mikunioz" and is located in this country: AU.
This item can be shipped worldwide.