Pacific C-Pro G1/4 PETG Tube 16mm OD Compression Fitting Chrome Featuring chrome plating, the compression fitting comes with special four rubber O-rings leak-free design and patented structure for ultimate loop management. 6 compression fittings are included in the kit. Pacific G1/4 90 Degree Adapter Chrome Finished in chrome-plated copper, the adapter fitting is in 360° revolvable design, and consists of two sealed O-rings, allowing users to redirect the fittings at a 90 degree angle for easier tube routing. 2 adapter fittings are included in the kit. V-Tubler PETG Tube 5/8 (16mm) OD 500mm (4 Pack) Manufactured from premium PETG, the rigid tubing provides custom PC water cooling configurations with reliability and durability from end to end.
Caution Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks: To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use. Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance. It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion. Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components. Thermaltake recommends the following steps to be taken after completing your water loop setup: It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000.It offers great performance while preventing the entire cooling system copper, brass, nickel, aluminum, and steel from corrosion. Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop. DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately Fill the reservoir to the top as it will prevent air from going into the pump If necessary tilt the system slightly from side to side to bleed the air out of the loop. Place some paper towels under fittings and joining points to test for leaks. Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop Before starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components.
Coolant might fade over time. 1150 1151 1155 1156 1366 2011 2066 AM2 AM2+ AM3 AM3+ AM4 FM1 FM2. The item "ThermalTake Pacific M360 DIY Hard Tube Liquid Cooling Kit, W4 CPU Block, PR22-D5" is in sale since Friday, April 26, 2019. This item is in the category "Computers/Tablets & Networking\Computer Components & Parts\Fans, Heatsinks & Cooling\Water Cooling". The seller is "scancomputers_int" and is located in Bolton.
This item can be shipped to United Kingdom.